Ceramic Heaters elements
STANDARD
Ceramic heating elements
Ceramic heating elements are used for the pre-heating, post-heating and stress relieving treatment for joint welding operation.
The modularity of the ceramic beads allows the production of a wide range of heating elements with different shapes and dimensions in order to fit as accurate as possible the different geometries of the pieces which has to be heated.
HEATING ELEMENTS STRUCTURE
• Ceramic beads made of alumina 98%
• Heating wire made of Ni/Cr – 80/20
• Max. temperature 1050°C
• Max. electric current flux 50A
TYPE OF RESISTANCES AND THEIR MAIN FEAUTURES
CAPTION
A Flexible side
B Rigid side
C Warm tail
D Cold tail
MAT
A and B with variable length
Code: RSTUS + four-digits progressive number
STRIP
A and B with variable length
Code: RSTRS + four-digits progressive number
FINGERS
A and B with variable length
Code: RDITA + four-digit progressive number (with tails out from open side)
Code: RDICT + four-digit progressive number (with tails out from close side)
Fingers heating elements can be produced with both MAT and STRIP shapes
SNAKE
A = variable length
B = 40mm
Codice: RSNAS + four-digit progressive number
ONE LINE
A = variable length
B = 10mm
Codice: RUNIS + four-digit progressive number
REPAIR CERAMIC BEADS
1 ISTUB0001
Id=9mm | White tube bead L=42mm Od=12mm Id=9mm
2 ISMAR0001/T
Half male end bead pink (pair) with hole
3 ISCFR0001/T
Half main body bead pink (pair) with hol
4 ISFER0001/T
Half femail end bead pink (pair) with hole
